Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Lennox Air Duct Cleaning in Almaden, CA
We provide independent Lennox air duct cleaning and repair across Almaden, focusing on the whole air path, from the return grille to the coil to the supply boots, rather than a quick vacuum pass. What makes our Lennox work different here is simple: Almaden’s oak and redwood canopy loads exterior grilles and attic boots with acorn hulls and fine organic grit, so a Lennox system in this valley needs debris clearing and sealing first, before cleaning means anything. Call (855) 506-8636 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.

We’re an independent Lennox service provider, not manufacturer-affiliated or authorized. Rodney Soto, our owner, grew up near Berryessa and completed his HVAC coursework at Evergreen Valley College before spending over a decade learning how residential duct systems actually fail. Since 2018, Elmwood Air Duct Cleaning has worked on Lennox systems across Almaden with professional Rotobrush and Nikro equipment, not portable shop vacs.
Why Almaden Residents Choose Us for Lennox Service
Most homes in Almaden were built between the 1960s and 1980s, and many still run their original rigid sheet-metal trunk-and-branch duct systems, often spliced with later flex-duct additions. When we open a Lennox cabinet in these houses, we know what we’re likely to find: baked flex collars, sagging branches, and coil faces matted with pollen and ash. That familiarity speeds up diagnosis and keeps the job honest. We’re not guessing at your Lennox system; we’ve seen this exact configuration enough times to know where the problems hide.
Our positioning is equipment-backed, not coupon-driven. We operate Rotobrush rotary-brush systems, the benchmark for dislodging compacted debris inside duct walls, and Nikro HEPA-rated vacuums that capture particulates instead of recirculating them. For elevated air-quality situations, fine particulates or biological contaminants, we have Abatement Technologies equipment on hand. We also work with Aprilaire and Honeywell whole-home filtration systems, so our recommendations can extend beyond the duct itself when a homeowner asks what else would help. We repair what we find, not just clean around it.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Common Lennox Air Duct Cleaning Problems We Solve in Almaden
- Attic furnace flex-duct collapse. Lennox furnaces mounted in unconditioned Almaden attics bake their flex-duct collars and plenum tape in summer heat until seams open. Once that happens, oak leaf grit and acorn debris get pulled straight into the return path, and the system starts circulating attic air. We reseal plenums and replace collapsed flex sections as part of the cleaning.
- Evaporator coil fouling after wildfire smoke episodes. Fall smoke settles into return-air intakes across the valley, and Lennox evaporator coils in older installations collect a fine mat of pollen and ash that chokes airflow and frosts the coil in summer. We clean the coil face and treat it so the system stops short-cycling on hot afternoons.
- Torn flex branches in crawlspaces. Original sheet-metal trunks with later flex additions often sag or tear where winter moisture and rodent activity concentrate in Almaden crawlspaces. A torn branch pulls crawlspace air and whatever lives under the house into your Lennox system. We repair or reroute the run.
- Debris-packed attic boots and exterior grilles. Under the oak and redwood canopy, gutters and eaves feed leaf litter and acorn grit into outdoor return-air and fresh-air intakes. We routinely pull packed leaf litter out of attic duct boots before cleaning can begin.
- Reduced static pressure from blower wheel buildup. Lennox blower wheels and secondary heat exchangers accumulate dust and organic grit that mastic-sealed legacy boots never filtered out. The result is uneven room airflow and a system working harder than it should. Cleaning restores blower performance and evens out delivery.
Lennox Service in Almaden: What Local Conditions Mean for Your Equipment
Almaden’s valley sits under a dense oak and redwood canopy, and the inversion-prone air at the foot of the Santa Teresa foothills means return-air intakes pull in settled smoke and dust from the surrounding hills. For a Lennox system, that translates into a specific pattern: exterior grilles under oaks pack with acorn hulls and fine organic grit, attic boots fill with leaf litter, and coils load up with a paste of pollen and wildfire ash. A generic duct cleaning that starts at the registers misses all of that. Our technicians clear the exterior grilles and boots first, seal the plenum, then clean the coil and air path. On a two-story ranch off the Almaden valley floor, we opened the attic boot above a Lennox Elite furnace and found it packed with acorn hulls and leaf litter that had worked in through the exterior return grille under the oaks. We vacuumed and sealed the boot, repaired a sagging flex branch spliced into the original sheet-metal trunk, and cleaned the evaporator coil, which had a visible mat of pollen and ash. Airflow at the farthest second-floor registers came back up, and the coil stopped short-cycling on hot afternoons.
Lennox Models & Products We Service in Almaden
We service Lennox Merit Series gas furnaces, Elite Series furnaces and air handlers, Dave Lennox Signature Collection systems, and Lennox XC/XC21 and XC25 air conditioners paired with matching indoor coils. For air-path work, like flex duct, mastic, and insulation, we use quality aftermarket materials because those aren’t brand-critical. Where a part is model-specific, an igniter, a control board, a coil assembly, we fit OEM Lennox parts. Rodney Soto tells owners honestly when sealing and coil cleaning will restore performance and when a failing heat exchanger or compressor makes replacement the better spend. That’s not a sales pitch; it’s the same conversation he’d have with a neighbor.
See the difference
Before
After
Before
After
Before
AfterLennox Service Pricing in Almaden
Pricing for Lennox air duct cleaning in Almaden depends on home size, the number of stories, how many systems you have, and what condition your ducts are in. The estimate is free, and the written estimate sets the final price, so there’s no vague quote that grows once the van is in your driveway. You’ll get one flat price per system agreed before work starts. Before-and-after photos of your own ducts are part of the service, so you can see exactly what was removed. Call (855) 506-8636 for an exact quote. Estimates are free.
Serving Almaden, CA – Our Local Coverage Area
We serve Almaden and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Lennox Air Duct Cleaning in Almaden
Because Almaden’s oak and redwood canopy drops acorns and fine organic grit directly onto exterior return-air and fresh-air grilles, and that debris works into the duct boots and plenums over time. We clear the grilles and boots before cleaning so the debris doesn’t just get recirculated. Call (855) 506-8636 for an exact quote, we answer 24/7.
Yes, because fall wildfire-smoke episodes settle ash into return-air intakes across the valley, and that ash loads up Lennox evaporator coils and blower wheels. Cleaning after smoke season, but before heavy winter use, gets the system ready for the months when windows stay closed.
Yes, attic-mounted furnaces in Almaden’s unconditioned attics bake flex-duct collars and plenum tape until seams open, so we check and reseal those connections during cleaning. Skipping that step means the system pulls attic air right back in after the cleaning is done.
In most cases, yes. We access the coil through the existing service panel or plenum opening, clean the coil face, and treat it, then verify airflow at the registers. Full disassembly is usually not needed unless the coil is heavily impacted or the plenum itself is compromised.
No. We’re an independent shop, not manufacturer-affiliated or authorized. We fit OEM Lennox parts where the part is model-specific and quality aftermarket materials for the air-path work, because that’s what actually fits and lasts.
Service Areas Near Almaden
We serve Almaden and the surrounding South Bay, including North San Jose, Alviso, Downtown San Jose, South San Jose, Spartan Keyes, East San Jose, Los Alamitos Creek, and Communications Hill. If you’re outside those neighborhoods, call and we’ll tell you straight whether we can get to you.
Book Your Lennox Service in Almaden Today
If you don’t know what’s in your ducts, you’re guessing at your air quality. Call (855) 506-8636 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. See what’s inside your ducts before and after.
Written by Rodney Soto, Owner at Elmwood Air Duct Cleaning, serving Almaden since 2018.